MAX881REUB+ (MAXIM INTEGRATED PRODUCTS)
Фиксированный DC/DC преобразователь напряжения с подкачкой заряда, 2.5В до 5.5В вход, -2В/10мА
The MAX881REUB+ is a low noise bias supply with power-OK for GaAsFET power amplifiers in 10 pin µMAX package. This inverting power supply is a charge pump inverter followed by a negative linear regulator. The input voltage range is 2.5V to 5.5V. The output is preset at -2V or can be set using two resistors to any voltage from -0.5V to (-VIN + 0.6V). It can deliver up to 4mA. The internal linear regulator also filters the output to 1mVp-p ripple and noise. The MAX881R includes power-OK (active-low POK) output that signals when negative voltage is within 7.5% of its set point. It protects GaAsFET by not allowing power to be applied to GaAsFET's drain until it is properly biased. The signal can be routed either to a microcontroller or directly to aswitch at the GaAsFET drain.
- Oscillator frequency of 100KHz
- Operating temperature range from -40°C to 85°C
- Power-OK signal to control GaAsFET drain switch
- 0.05µA logic controlled shutdown current and 500µA supply current
- 1ms start-up and 1mVp-p output ripple
- Operates with one 4.7µF and three 0.22µF capacitors (no inductors needed)
- Output load regulation of 2mV/mA at VIN >= 2.7V, IOUT = 0 to 4mA
Области применения
Управление Питанием, Переносные Устройства, Потребительская Электроника
Количество Выводов:
10вывод(-ов)
Корпус ИС DC / DC Преобразователя:
µMAX
Линейка Продукции:
-
Максимальная Рабочая Температура:
85°C
Максимальное Входное Напряжение:
5.5В
Максимальное Регулируемое Выходное Напряжение:
-
Минимальное Входное Напряжение:
2.5В
Минимальное Регулируемое Выходное Напряжение:
-
Соответствует Фталатам RoHS:
Будет Указано Позже
Стандарты Автомобильной Промышленности:
-
Тип Выхода:
Фиксированный
Топология (Общая Схема Соединений):
Инвертирующий
SVHC (Особо Опасные Вещества):
No SVHC (15-Jan-2018)
RoHS статус:
Да
Выходные параметры
Выходной Ток:
10мА