MCP2562-E/P (MICROCHIP)
CAN шина, приемопередатчик, CAN, LIN, 1, 1, 4.5 В, 5.5 В, DIP
The MCP2562-E/P is a second generation high-speed CAN Transceiver serves as an interface between a CAN protocol controller and the physical two-wire CAN bus. The device meets the automotive requirements for high-speed (1Mb/s), low quiescent current, electromagnetic compatibility (EMC) and electrostatic discharge (ESD). The device family members are MCP2561 with SPLIT pin and MCP2562 with VIO pin. It serves as the interface between a CAN protocol controller and the physical bus. The MCP2562 device provides differential transmit and receive capability for the CAN protocol controller and is fully compatible with the ISO-11898-2 and ISO-11898-5 standards. It will operate at speeds of up to 1Mb/s. Typically, each node in a CAN system must have a device to convert the digital signals generated by a CAN controller to signals suitable for transmission over the bus cabling (differential output).
- AEC-Q100 Grade 0
- 5µA Typical very low standby current
- VIO supply pin to interface directly to CAN controllers and microcontrollers
- SPLIT output pin to stabilize common mode in biased split termination schemes
- CAN bus pins are disconnected when device is unpowered
- Detection of ground fault - Permanent dominant detection on TXD
- Power-on reset and voltage brown-out protection on VDD pin
- Protection against damage due to short-circuit conditions (positive or negative battery voltage)
- Protection against high-voltage transients in automotive environments
- Automatic thermal shutdown protection
- Suitable for 12 and 24V systems
- Up to 112 nodes can be connected
- Meets or exceeds stringent automotive design requirements
- High-noise immunity due to differential bus implementation
- High electrostatic discharge (ESD) protection on CANH and CANL
Области применения
Авто, Связь и Сеть
Предупреждения
ESD sensitive device, take proper precaution while handling the device.
Количество RX Буферов:
1
Количество Буферов TX:
1
Количество Выводов:
8вывод(-ов)
Линейка Продукции:
-
Максимальная Рабочая Температура:
125°C
Максимальное Напряжение Питания:
5.5В
Минимальная Рабочая Температура:
-40°C
Минимальное Напряжение Питания:
4.5В
Соответствует Фталатам RoHS:
Да
Стандарты Автомобильной Промышленности:
-
Стиль Корпуса Интерфейса:
DIP
Тип Интерфейса ИС:
CAN, LIN
SVHC (Особо Опасные Вещества):
No SVHC (27-Jun-2018)
RoHS статус:
Да