UMFT240XE-01 (FTDI)

Главная/Макетные Платы, Инструменты Оценки/Комплекты Разработчика Устройств Взаимодействия / Связи/UMFT240XE-01 (FTDI)

Описание
Характеристики

Макетная плата, USB - 245 8-битный FIFO, обнаружение зарядки

The UMFT240XE-01 is an USB to 8-bit 245 FIFO Development Module with a 0.6-inch row pitch. It is suitable for FT240XQ USB interface bridging integrated circuit device. It is an interface with a battery charger detection feature, which can allow batteries to be charged with a higher current from a dedicated charger port (without the FT240X being enumerated). In addition, asynchronous and synchronous bit bang interface modes are available. The internally generated clock (6, 12 and 24MHz) can be brought out on one of the CBUS pins to be used to drive a microprocessor or external logic. It is designed to plug into a standard 0.6-inch wide 16-pin DIP socket.

Entire USB protocol handled on the chip
No USB specific firmware programming required
Fully integrated 2048-byte MTP memory
Fully integrated clock generation with no external crystal required
1Mbps data transfer rate
512-byte receive buffer and 512-byte transmit buffer
Virtual COM Port and Direct drivers eliminate the requirement for USB driver development
Configurable CBUS I/O pins
Device supplied pre-programmed with unique USB serial number
Supports bus powered, self powered and high-power bus powered USB configurations

Integrated +3.3V level converter for USB I/O
True 3.3V CMOS drive output and TTL input
Transmit and receive LED drive signals
Configurable I/O pin output drive strength
Battery charger detection may be used by mobile devices to detect the presence of a charger
Integrated power-on-reset circuit
8mA typical low operating current
125µA typical USB suspend current
Low USB bandwidth consumption
UHCI/OHCI/EHCI host controller compatible