VA800A-SPI (BRIDGETEK)
USB интерфейс, FT232H, USB, 5 В
The VA800A-SPI is an USB 2.0 high-speed to MPSSE SPI Module, small electronic circuit board, utilising the FTDI FT232H. The 10-pin connector on the module fits directly to the FTDI VM800B and VM800C graphic display modules. This allows direct control of the EVE FT800 devices with an SPI interface from a USB host. All USB signalling and protocols are handled on the module. The VA800A-SPI MPSSE module is configured for SPI only. The 10-pin connector fits to the VM800B and VM800C graphic display modules directly.
- USB 2.0 high-speed (480Mbps) and full speed (12Mbps) compatible
- Entire USB protocol handled on the chip - No USB-specific firmware programming required
- USB type-B micro connector
- USB bus powered
- Synchronous serial (MPSSE) data rates of up to 30Mbps on SPI
- 1kb receive and transmit buffers for high data throughput
- 3.3V level IO
- Power indicator LED
- SPI SS# active indicator LED
- Adjustable receive buffer timeout
- Support for USB suspend and resume
- Low operating and USB suspend current
- Low USB bandwidth consumption
- UHCI/OHCI/EHCI host controller compatible
- -40 to +85°C Operating temperature range
- FTDI chip's royalty-free D2XX drivers eliminate requirement for USB driver development in most cases
Области применения
Компьютеры и Периферия
Интерфейс Модуля:
USB
Линейка Продукции:
-
Максимальное Напряжение Питания:
5В
Минимальное Напряжение Питания:
-
Поддерживаемые Устройства:
FT232H
Применение Модуля:
-
Соответствие Стандарту:
-
Соответствует Фталатам RoHS:
Будет Указано Позже
SVHC (Особо Опасные Вещества):
No SVHC (17-Dec-2015)
RoHS статус:
Да